| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|
| 3953 |
2019-04-29 |
Lab none |
Tested |
Lab none |
Continued testing in lab and RH is consistently bad. Do not use. |
| 3934 |
2019-04-24 |
Lab none |
Tested |
Lab none |
Tested overnight in the lab. This sensor has an extension cable soldered on. The RH was consistently 5-7% lower than the other 3 sensors (L1740398, T2130005, G4540023). I removed the extension cable, and the numbers were still low. I removed the humidity chip, and it read 150%. When I replaced the humidity chip, the RH was within 2-4% of the other 3 sensors. I added the same extension cable back on, and the numbers became low. This sensor doesn't look consistent and needs more testing before it can be deployed. |
| 3865 |
2019-01-31 |
East End RH & Temp |
Removed |
Lab none |
Removed from EE b/c RH was not working (ranged only b/t 10 and 13%). It was replaced by HMP60 sn L1740420. |
| 3850 |
2019-01-24 |
Lab none |
Installed |
East End RH & Temp |
Installed at EE to replace G4540023, which was brought back to the lab for inspection. |
| 3845 |
2019-01-23 |
Lab none |
Maintenance |
Lab none |
Spliced on a longer cable so total length is ~24'. New wiring colors are: Orange-Temperature, Blue-RH, White-SignalReference, Green-Control, Red-12V, Black-G, Bare/Shield-AG |
| 3358 |
2018-03-12 |
Lab none |
Tested |
Lab none |
Tested in the lab and numbers seems reasonable. |
| 3340 |
2018-03-05 |
Lab none |
Maintenance |
Lab none |
All three o-rings were replaced. Should be good to go. |
| 3310 |
2018-01-30 |
Lab none |
Notes |
Lab none |
This HMP45 needs 3 o-rings replaced before field deployment. |
| 3261 |
2017-12-19 |
Twitchell Alfalfa |
Removed |
Lab none |
Removed from the HMP inter-comparison at Twitchell Alfalfa |
| 3274 |
2017-12-18 |
Lab none |
Installed |
Twitchell Alfalfa |
Installed at Twitchell Alfalfa for an inter-comparison of HMPs |
| 3087 |
2017-09-26 |
East End-Temp2 RH & Temp |
Removed |
Lab none |
Brought back to the lab with the decommissioning of the East End closed canopy temporary tower 2 |
| 2868 |
2017-06-14 |
Lab none |
Installed |
East End-Temp2 RH & Temp |
Installed on the East End Temporary Tower #2 Closed Canopy location with the initial tower set up. |
| 2690 |
2017-04-04 |
Twitchell Rice RH & Temp |
Removed |
Lab none |
Removed with the decommissioning of the Twitchell Rice site. |
| 1316 |
2013-08-28 |
Lab none |
Installed |
Twitchell Rice RH & Temp |
Installed on the Twitchell tower to replace sn U3030032 that was removed for bad RH readings. |
| 593 |
2012-05-02 |
Factory |
Repair |
Lab none |
The RH sensor and probe were replaced. A new handle was ordered. The unit was calibrated. |
| 576 |
2012-03-28 |
Lab none |
Shipped |
Factory |
Sent to Vaisala for repair. Unreasonable analog readings, some corrosion on circuit board. |
| 266 |
2011-01-18 |
Twitchell Rice RH & Temp |
Removed |
Lab none |
This sensor was removed from the Twitchell tower because it was giving bad readings. |
| 267 |
2009-04-03 |
Lab none |
Installed |
Twitchell Rice RH & Temp |
This sensor was installed with the new eddy tower at Twitchell Rice. |
| 4815 |
2002-06-06 |
Vaira RH & Temp |
Removed |
Lab none |
Removed from Vaira for calibration. Replaced by sn W0730037. |
