Equipment and Calibration
View History
Equipment Entry
|
Documents
No documents found
History
| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|---|---|---|---|---|
| 5190 | 2021-03-11 | Lab none | Installed | Hill Slough Heat Flux Plate B | Installed at Hill Slough with site setup. |
| 4959 | 2020-11-12 | Sherman Wetland-Temp1 Heat Flux Plate B | Removed | Lab none | Removed with decommissioning of Sherman Wetland Temp tower. Brought back to the lab for cleanup. |
| 4492 | 2020-05-21 | Sherman Wetland-Temp1 Heat Flux Plate B | Moved | Sherman Wetland-Temp1 Heat Flux Plate B | Moved from 5cm depth and 30 degree angle to 2cm depth below soil surface and horizontal. |
| 4342 | 2020-01-30 | East Pond Heat Flux Plate C | Moved | Sherman Wetland-Temp1 Heat Flux Plate B | Removed with the decommissioning of the EP tower and installed at the new SW Temporary site 1250m upwind of the Permanent Tower. |
| 3427 | 2018-04-17 | Lab none | Installed | East Pond Heat Flux Plate C | Installed at EP tower as part of initial site set up in profile C (South) and mux channel 10 |
| 3339 | 2018-02-27 | Lab none | Repair | Lab none | Re-stripped cable so the correct ground wire was showing. The brown wire had been used as the ground, but that is not connected to anything. I fixed the cable so the three exposed wires are white (sig +), green (sig -) and bare (ground). |
| 3090 | 2017-09-26 | East End-Temp2 Heat Flux Plate B | Removed | Lab none | Brought back to the lab with the decommissioning of the East End closed canopy temporary tower 2. |
| 2866 | 2017-06-14 | Lab none | Installed | East End-Temp2 Heat Flux Plate B | Installed on the East End Temporary Tower #2 Closed Canpoy location with the initial tower set up. |
| 2687 | 2017-04-04 | Twitchell Rice Heat Flux Plate A | Removed | Lab none | Removed with the decommissioning of the Twitchell Rice site. |
| 1781 | 2015-04-09 | Lab none | Installed | Twitchell Rice Heat Flux Plate A | Installed at rice as SHF1 in mux channel 16 |
| 1970 | 2014-10-17 | Factory | Calibration | Factory | Initial factory calibration: a0 = 0 a1 = 62.69 uV/(W/m2) |