Equipment and Calibration
View History
Equipment Entry
| Instrument: | RH & Temp |
| Manufacture: | Vaisala |
| Model No: | HMP45AC |
| Serial No: | T1250012 |
| Tag No: | |
| Acquisition Date: | 2013-04-10 |
| Project: | Siyan |
| Location on 2021-12-14: | Lab, 1.8m |
| Notes: |
Recovered from old equipment from a project of Siyans |
|
|
Documents
No documents found
Report: HMP RH and AirT Comparison 12-2017 - 2017-12-18
Report: HMP intercomparison - BA 11/2021 - 2021-11-04
History
| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|
| 5638 |
2021-12-14 |
Bouldin Alfalfa |
Removed |
Lab none |
Removed from BA at the conclusion of the HMP intercomparison |
| 5587 |
2021-11-18 |
Lab none |
Installed |
Bouldin Alfalfa none |
Installed on BA tower for an HMP45 intercomparison with the tower HMP155. |
| 5448 |
2021-09-03 |
Bouldin Alfalfa |
Removed |
Lab none |
Removed from BA bouncer tower, where it was the upper T/RH sensor. It was replaced by sn T2820180. |
| 5446 |
2021-08-04 |
Lab none |
Installed |
Bouldin Alfalfa none |
Installed on the BA bouncer tower next to the upper sonic for the advection experiment. It was wired to U9/U10. |
| 4972 |
2020-11-19 |
Bouldin Alfalfa RH & Temp |
Removed |
Lab none |
Removed from Bouldin Alfalfa to be returned to Siyan. Replaced by sn G4540021 |
| 3681 |
2018-08-23 |
Lab none |
Installed |
Bouldin Alfalfa RH & Temp |
Installed on BA to replace an HMP60 with low temperature readings. This sensor was in the TA inter-comparison T slope was 1.0462 and RH slope was 1.0369. |
| 3262 |
2017-12-19 |
Twitchell Alfalfa |
Removed |
Lab none |
Removed from the HMP inter-comparison at Twitchell Alfalfa |
| 3275 |
2017-12-18 |
Lab none |
Installed |
Twitchell Alfalfa |
Installed at Twitchell Alfalfa for an inter-comparison of HMPs |
| 2815 |
2017-06-01 |
Tonzi-Tower |
Removed |
Lab none |
Removed from the lower middle position of CO2 profile system on the Tonzi Tower. At least one has not been working and all need to be compared against each other for drift. |
| 969 |
2013-04-19 |
Lab none |
Installed |
Tonzi-Tower |
Installed on the Tonzi tower at the 2nd from bottom (1.8m) CO2 profile inlet location. Wired to the AM16/32 multiplexor connected to the tower top CR23X |
