Back to site list

Site: Bouldin Corn (US-Bi2)

Tyler working on chambers

No description found

Ameriflux Site Info

Last field site visit:

2024-11-19 14:30:00 Field has been tilled, rad boom was folded in since last visit, storms coming later this week

Equipment installed at the site:
Apogee Narrow Band S2-411
Arable Weather Station Mark 3
Arable Weather Station Mark II
Campbell Sci. Multiplexer AM16/32B
Campbell Sci. Multiplexer AM25T
Campbell Sci. Data Logger CR1000
Campbell Sci. Data Logger CR10X
Campbell Sci. Water Level CS450
Campbell Sci. Soil Moisture Probe CS655
Campbell Sci. RH & Temp HygroVUE10
Campbell Sci. Interface NL115
Decagon-METER Narrow Band SRS-Pi PRI
Delta-T Soil Moisture Probe ML3
Gill Anemometer WM 1590
Hukseflux Heat Flux Plate HFP01
Kipp & Zonen Net Radiometer CNR1
Kipp & Zonen PAR Sensor PQS 1
Licor Gas Analyzer LI-7500A
Licor Interface LI-7550
Licor Gas Analyzer LI-7700
PurpleAir Air Quality Sensor PA-II-SD
StarDot Camera SD130BN
Texas Electronics Precipitation TE525MM

Data Streams:

CodeDescription
BC_flux 30min averages of high frequency flux data from Licor GHG files
BC_met Micromet data from the Bouldin Corn site recorded by a CR1000 as 30min averages of 10sec samples.
BC_pa Data from a PurpleAir air quality sensor.
BC_arable Data from an Arable Mark weather station. Raw data is recorded at 5min intervals and some calculated values like ppt are produced at hourly intervals.
BC_processed Data loaded from the Level 1 processed data including fluxes and turbulence data
BC_processed3 Gap filled and partitioned data from Level 3 processing files
BC_fda Soil CO2 flux from an Eosense Forced Diffusion Chamber
BC_fdb Soil CO2 flux from an Eosense Forced Diffusion Chamber
BC_fdc Soil CO2 flux from an Eosense Forced Diffusion Chamber
BC_irtsr Surface temperature from two Apogee IRT sensors one pointing north and the other south at a 45 deg declination. These are recorded at both 2Hz and 30min averages for surface renewal by Kevin Tu.