Equipment and Calibration
View History
Equipment Entry
|
Documents
No documents found
History
| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|---|---|---|---|---|
| 5189 | 2021-03-11 | Lab none | Installed | Hill Slough Heat Flux Plate A | Installed at Hill Slough with site setup. |
| 4958 | 2020-11-12 | Sherman Wetland-Temp1 Heat Flux Plate A | Removed | Lab none | Removed with decommissioning of Sherman Wetland Temp tower. Brought back to the lab for cleanup. |
| 4491 | 2020-05-21 | Sherman Wetland-Temp1 Heat Flux Plate A | Moved | Sherman Wetland-Temp1 Heat Flux Plate A | Moved from 15cm depth to 2cm depth below soil surface. |
| 4341 | 2020-01-30 | East Pond Heat Flux Plate B | Moved | Sherman Wetland-Temp1 Heat Flux Plate A | Removed with the decommissioning of the EP tower and installed at the new SW Temporary site 1250m upwind of the Permanent Tower. |
| 3426 | 2018-04-17 | Lab none | Installed | East Pond Heat Flux Plate B | Installed at EP tower as part of initial site set up in profile B (west) and mux channel 10 |
| 3338 | 2018-02-27 | Lab none | Repair | Lab none | I soldered on a cable and reinforced the cable-sensor connection with silicone. This sensor tested sufficiently against sn 00244 and sn 10809. |
| 3143 | 2017-10-13 | East End-Temp3 Heat Flux Plate A | Removed | Lab none | Removed from East End Boardwalk tower (temporary tower #3) with decommissioning of the site. The cable has been chewed, and the cable-head connection needs to be repaired. |
| 2877 | 2017-06-23 | Lab none | Installed | East End-Temp3 Heat Flux Plate A | Installed at the East End Temporary Tower #3 Boardwalk location with the initial setup of the site. |
| 2779 | 2017-05-26 | Lab none | Repair | Lab none | Added silicone around the connection between wire and plate. Soldered new cable onto sensor and used clear heat shrink to attach sn and calibration information onto new cable. |
| 1841 | 2015-05-12 | Sherman Island Heat Flux Plate C | Removed | Lab none | Removed with the decommissioning of the Sherman Cow Pasture site. The cable is all cracked and needs replacing. |
| 5250 | 2007-06-13 | Lab none | Installed | Sherman Island Heat Flux Plate C | Installed at Sherman Island HFP C to replace sn 000142 |
| 49 | 2001-05-25 | Factory | Calibration | Factory | Initial factory calibration: 61.5 uV/W/m2
Heater resistnace: 101.2 Ohm Heater area: 0.003885 m2 |