Equipment and Calibration History

History for Hukseflux HFP01SC 00245

Rec No.DateLoc FromTitleLoc ToNotes
5189 2021-03-11 Lab none Installed Hill Slough Heat Flux Plate A Installed at Hill Slough with site setup.
4958 2020-11-12 Sherman Wetland-Temp1 Heat Flux Plate A Removed Lab none Removed with decommissioning of Sherman Wetland Temp tower. Brought back to the lab for cleanup.
4491 2020-05-21 Sherman Wetland-Temp1 Heat Flux Plate A Moved Sherman Wetland-Temp1 Heat Flux Plate A Moved from 15cm depth to 2cm depth below soil surface.
4341 2020-01-30 East Pond Heat Flux Plate B Moved Sherman Wetland-Temp1 Heat Flux Plate A Removed with the decommissioning of the EP tower and installed at the new SW Temporary site 1250m upwind of the Permanent Tower.
3426 2018-04-17 Lab none Installed East Pond Heat Flux Plate B Installed at EP tower as part of initial site set up in profile B (west) and mux channel 10
3338 2018-02-27 Lab none Repair Lab none I soldered on a cable and reinforced the cable-sensor connection with silicone. This sensor tested sufficiently against sn 00244 and sn 10809.
3143 2017-10-13 East End-Temp3 Heat Flux Plate A Removed Lab none Removed from East End Boardwalk tower (temporary tower #3) with decommissioning of the site. The cable has been chewed, and the cable-head connection needs to be repaired.
2877 2017-06-23 Lab none Installed East End-Temp3 Heat Flux Plate A Installed at the East End Temporary Tower #3 Boardwalk location with the initial setup of the site.
2779 2017-05-26 Lab none Repair Lab none Added silicone around the connection between wire and plate. Soldered new cable onto sensor and used clear heat shrink to attach sn and calibration information onto new cable.
1841 2015-05-12 Sherman Island Heat Flux Plate C Removed Lab none Removed with the decommissioning of the Sherman Cow Pasture site. The cable is all cracked and needs replacing.
5250 2007-06-13 Lab none Installed Sherman Island Heat Flux Plate C Installed at Sherman Island HFP C to replace sn 000142
49 2001-05-25 Factory Calibration Factory Initial factory calibration: 61.5 uV/W/m2
Heater resistnace: 101.2 Ohm
Heater area: 0.003885 m2