Equipment and Calibration
View History
Equipment Entry
|
Documents
No documents found
History
| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|---|---|---|---|---|
| 967 | 2013-04-24 | Lab none | Installed | Tonzi-SoilCO2 | Installed as SHF#2 on the soil CO2 CR23X and placed in the ground to the south of the data logger box |
| 782 | 2012-09-10 | Lab none | Repair | Lab none | I shortened the cable on this SFH plate. The cable had been spliced in the field where a large portion of it was tangled in the Tules and much longer than necessary. |
| 777 | 2012-09-06 | Mayberry Heat Flux Plate Water | Removed | Lab none | Reomved from the Tule Tower at Mayberry. SHF under a meter of water is questionable and these plates would be more useful else where. Removed to be calibrated and repurposed - not planning to replace. |
| 331 | 2011-03-01 | Lab none | installed | Mayberry Heat Flux Plate Water | Installed on the Mayberry tule tower measuring soil heat flux in water. |
| 296 | 2011-02-03 | Tonzi-Floor | Removed | Lab none | Removed from under the tree near the floor tower. |
| 144 | 2010-06-24 | Lab none | Installed | Tonzi-Floor | This sensor was installed near the under tree radiation sensor in the floor site. |
| 143 | 2010-06-15 | Lab none | Repair | Lab none | One of the wires was cut by animals. Spliced. |
| 140 | 1999-09-09 | Factory | Calibration | Factory | Initial factory calibration: 58.4 uV/W/m2
Heater resistance: 105.8 Ohm Heater area: 0.003885 m2 |