1. Checked and downloaded data from PC at Tower, Floor.


2. Joe downloaded data at Vaira.


3. Joe installed 4-way radiaometers and diffusive light
   sensor at Tonzi.


4. Swapped memory cards of CR1000s at three sites. Everything
   worked well.


5. Calibrated CO2 profile system; Zero ~10 ppm offset.


6. Collected grass samples for grass LAI, 3 for open even,
   3 for cow poop spot.


7. Read dendrometers


8. Measured soil moisture


9. Measure groundwater well:

1. Fence and gate power: 12 v.


2. Panel and Batteries: - v; - amps;
   - amps.


3. Joe downloaded data and swapped the memory cards of
   CR1000.


4. Check the fans of air temp and relative humidity sensors
   at Vaira. YES!


5. Check levels of Radiation sensors, clear up surfaces.YES!


6. Check rain gage, make sure not clogged. YES!


7. Closed gate and set up fence. YES!


8. Collected grass samples for grass LAI.

Tonzi_Tower Site

1. Fence and gate power: 12 v.


2. Panel and Batteries: - v;
   - amps; - amps.


3. Reading from Gillsonic screen before downloading data.
   (The value of H₂O and CO₂ should be in the range of
   0 – 5 v.)

1. downloading data from PC.


2. Swapped the memory cards of CR1000.


3. check the fans of air temp. and relative humidity sensors
   on the tower and the floor. YES!


4. Check rain gage, make sure not clogged. YES!


5. Check calibration cylinders;

1. close gate and set up fence. YES!

1. Fence and gate power: 12
   v.


2. Panel and Batteries: - v;
   - amps; - amps. (about 7:00 am local time)


3. Reading from Gillsonic screen before downloading data.
   (The value of H₂O and CO₂ should be in the range of
   0 – 5 v.)

1. downloading data from PC. YES!


2. Swapped the memory cards of CR1000.


3. Check MD-9 system connections YES!

1. Close gate and set up fence. YES!