Equipment and Calibration History
History for Kipp & Zonen PQS 1 110340
| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|---|---|---|---|---|
| 5480 | 2021-10-06 | Lab none | Installed | Tonzi PAR Sensor Incoming | Installed at Tonzi to replace sn 010164 due to bad readings from a broken wire. |
| 5408 | 2021-08-11 | Tonzi PAR Sensor Under-A | Removed | Lab none | Removed from Tonzi near z-cam 2 because the data seems not so useful. |
| 4438 | 2020-04-18 | Lab none | Installed | Tonzi PAR Sensor Under-A | The PAR sensor was installed at Tonzi on the z-cam 1 post to measure below canopy PAR. It is connected the the fmet CR23x |
| 4018 | 2019-07-25 | East End PAR Sensor Incoming | Removed | Lab none | Removed from EE because it had been spiky in the last month. It was replaced sn 10162. |
| 1710 | 2015-01-20 | Lab none | Installed | East End PAR Sensor Incoming | Reinstalled after being removed when the scaffolding fell over. This sensor is pointing up and measuring PARin. |
| 1695 | 2015-01-05 | East End PAR Sensor Incoming | Removed | Lab none | Removed from the site due to the tower falling over in the wind on 2014-12-30. Likely undamaged. |
| 1664 | 2013-12-19 | Lab none | Installed | East End PAR Sensor Incoming | Reinstalled in the upward facing position after repairing the cable from being sheared off in the folding boom. |
| 1151 | 2013-11-25 | DWR Corn | Removed | Lab none | In reinstalling on the new Twitchell East End Wetland site the cable for this sensor was sheared of by the folding arm. Removed for repair in the Lab. The out going sensor was moved to the incoming location. |
| 653 | 2012-06-21 | Lab none | Installed | DWR Corn | Installed in the upward facing position on the folding boom on the top northeast corner of the scaffolding and extending to the east. It had a longer cable spliced on to it and replaced sn 110338. |
| 4451 | 2011-11-18 | Factory none | Calibration | Factory none | Initial factory calibration 4.61uV/(umol/m2/s) |