| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|
| 5429 |
2021-08-26 |
Lab none |
Notes |
Lab none |
Partly cleaned this sensor and tried to take the cable off. However, the connector at the top of the sensor twists loose from the body of the sensor so I don't think it's worth keeping. I'm not sure if the connector was already loose, or if I loosened it trying to table the cable off. |
| 5237 |
2021-04-13 |
Lab none |
Tested |
Lab none |
Tested in the lab and the CO2 signal responded to my breath. I'll keep it running for a while and see if the noise comes back; maybe it just needs a new connector/cable. This sensor needs a scrubbing. |
| 5208 |
2021-03-16 |
Mayberry CO2 Probe A |
Removed |
Lab none |
Removed from MB b/c it was sporadically reading noise. it was replaced by sn GP20150111. |
| 4410 |
2017-05-25 |
Mayberry CO2 Probe A |
Moved |
Mayberry CO2 Probe A |
Moved to floating boom. Depth is ~-15cm below water level. Co-located with sn GP20150111 (which was removed 2017-08-16). |
| 4409 |
2017-05-10 |
Mayberry CO2 Probe A |
Moved |
Mayberry CO2 Probe A |
Adjusted depth? on fixed boom. Depth is -10cm based on water level on 2017-05-10. All three eosCO2 sensors (sn GP20160070, sn GP20160069, sn GP20150111) are at -10cm depth because of low water level. |
| 2638 |
2017-02-23 |
Lab none |
Installed |
Mayberry CO2 Probe A |
Installed on the new water sensor boom in the top location - currently 8cm below the water surface |
