| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|
| 3319 |
2018-01-31 |
Lab none |
Installed |
East End Heat Flux Plate A |
Installed at EE in open patch left of rad boom. |
| 3033 |
2017-08-30 |
East End-Temp1 Heat Flux Plate A |
Removed |
Lab none |
Removed from Temporary Tower #1 Open Water. Its cable was chewed through. |
| 2856 |
2017-06-01 |
Lab none |
Installed |
East End-Temp1 Heat Flux Plate A |
Installed at the East End Temporary Tower #1 Open Water location with the initial set up of this site. |
| 1839 |
2015-05-12 |
Sherman Island Heat Flux Plate A |
Removed |
Lab none |
Removed with the decommissioning of the Sherman Cow Pasture site. |
| 1329 |
2012-11-15 |
Lab none |
Installed |
Sherman Island Heat Flux Plate A |
Reinstalled after calibration by Sebastian in BC. The original calibration factor was found to be stable. The plate was reinstalled at 2 cm depth maybe 4 meters to the west of the tower as far as the cable would allow. |
| 778 |
2012-09-06 |
Factory |
Removed |
Lab none |
Removed from Sherman (SHF #1) for calibration. This plate had been reading oddly rencently and was found to be just barely below the surface. It will be replaced after calibration. |
| 48 |
2010-02-05 |
Factory |
Calibration |
Factory |
cal cefficient 62.3 |
| 128 |
2005-09-29 |
Factory |
Calibration |
Factory |
Initial Factory calibration 62.3 uV/W/m2 |
