Equipment and Calibration History
History for Hukseflux HFP01 001604
| Rec No. | Date | Loc From | Title | Loc To | Notes |
|---|---|---|---|---|---|
| 3319 | 2018-01-31 | Lab none | Installed | East End Heat Flux Plate A | Installed at EE in open patch left of rad boom. |
| 3033 | 2017-08-30 | East End-Temp1 Heat Flux Plate A | Removed | Lab none | Removed from Temporary Tower #1 Open Water. Its cable was chewed through. |
| 2856 | 2017-06-01 | Lab none | Installed | East End-Temp1 Heat Flux Plate A | Installed at the East End Temporary Tower #1 Open Water location with the initial set up of this site. |
| 1839 | 2015-05-12 | Sherman Island Heat Flux Plate A | Removed | Lab none | Removed with the decommissioning of the Sherman Cow Pasture site. |
| 1329 | 2012-11-15 | Lab none | Installed | Sherman Island Heat Flux Plate A | Reinstalled after calibration by Sebastian in BC. The original calibration factor was found to be stable. The plate was reinstalled at 2 cm depth maybe 4 meters to the west of the tower as far as the cable would allow. |
| 778 | 2012-09-06 | Factory | Removed | Lab none | Removed from Sherman (SHF #1) for calibration. This plate had been reading oddly rencently and was found to be just barely below the surface. It will be replaced after calibration. |
| 48 | 2010-02-05 | Factory | Calibration | Factory | cal cefficient 62.3 |
| 128 | 2005-09-29 | Factory | Calibration | Factory | Initial Factory calibration 62.3 uV/W/m2 |