Field Notes
<--2005-03-22 00:00:00 | 2005-03-26 15:00:00-->Phenocam link: Searching...
Tonzi: 2005-03-24 12:00:00 (DOY 83)
Author: Siyan Ma
Others: Qi Chen, Ted
Summary: Swapped Li-7500 in Vaira (Remove #65, install #41). Because Ted was there, I didn't check the flux system. Some serious problems mentioned by Ted.
When: Date: 3/24/2005 , Day: 84 , Watch Time: 12:00pm . Where: Tonzi/Vaira Ranch Who: Siyan, Qi Chen Weather: Partially cloudy, ground very wet, flooding on Tue. Phenology: Oak leaves comes out, ~1cm long. Flowers start coming out on the grassland. Summary
· Ted found he didn’t install Licor-7500 on Tower site properly last time right before Hank was here. We got bad data during the comparison period. · We need swap Tower’s Licor-7500 as soon as possible. · Ted got shock by fence when he’s holding LED sensor, causing one channel of the sensor was out of range. · Ted found there was some standing water in the lowest filter of CO2 profile system. So, he decided to stay in Tonzi one more night to fix the problem and also run responding curves.
1) Compare two sensors on the top of the tower · SetUP: Rmt, Above, the same clock, sampling frequency = 15 seconds, sampling period = 10 mins. (using memory ~3%). · Lenses are covered with 180oC mask. · Direction is opposite to the Sun. 2) Leave one sensor on the tope the tower, holding tightly with a bondage · SetUP: Rmt Above. sampling frequency =15 seconds. Sampling period = 1 hr. 3) Hold the one sensor in the level and do the “Below” measurement along “V” transects. · SetUP: Rmt Blowe, Avg = 0. sampling frequency = · Same mask as the tower one. · Same direction as the tower one. The number of files: DDB set 1 – compare two sensors on the top of the tower 2 – transect 3 – coming radiation measured in open area 4 – compare two sensors on the top of the tower 5 6 7 8 Qi set 1 – compare two sensors on the top of the tower 2 – incoming radiation on the tower 3 –
1) To measure soil moisture profile, set up MODE = 008 2) To measure soil moisture using single diode probe, set up MODE = 009
|
Field Data
No tank data
No TZ Well data found
No TZ Moisture Point data found
No VR Moisture Point data found
No TZ grass heigth found
No VR grass heigth found
No TZ Tree DBH found
No water potential data found
No TZ Grass Biomass data found
No TZ OakLeaves Biomass data found
No TZ PineNeedles Biomass data found
0 photos found
16 sets found
No data found for TZ_Fenergy.
11 TZ_tmet graphs found
No data found for TZ_soilco2.
Can't check TZ_mixed
3 TZ_mixed graphs found
No data found for TZ_fflux.
8 TZ_fmet graphs found
No data found for TZ_tram.
No data found for TZ_co2prof.
No data found for TZ_irt.
1 TZ_windprof graphs found
No data found for TZ_tflux.
2 TZ_sm graphs found
Can't check TZ_met
1 TZ_met graphs found
Can't check TZVR_mixed
No data found for TZ_osu.
No data found for TZ_fd.
Tonzi Z-cam data