Equipment and Calibration History
View Equipment |
| Date: |
2020-10-26 |
| From: |
Lab - none |
| To: |
Lab - none |
| Title: |
Repair |
| Notes: |
The cable insulation on this sensor was rotted. I cut the cable off near the sensor and spliced on a new cable. I also added an aluminum bracket to provide strain relief and used liquid electrical tape to seal the hole where the cable enters the sensor. The white wire (+) had a nick in its insulation right at the point where it entered the sensor that I covered with heat shrink. |
| Entered by: |
Joe Verfaillie |
|
|
