Equipment and Calibration
Equipment history at Tonzi| ALL | | Anemometer || Barometer || Battery Bank || Camera || CO2 Probe || Data Logger || Forced Diffusion || Gas Analyzer || Heat Flux Plate || Infrared Temperature || Interface || LED sensor || Moisture Point || Multiplexer || Narrow Band || Net Radiometer || PAR Sensor || Precipitation || Radio || RH & Temp || Soil Moisture Probe || Soil Water Potential || Solar Controller || Solar Panel || Water Level || Weather Station |
SELECT a.recno, a.eh_date, a.eh_loc1, a.eh_loc2, IF(a.eh_loc2=:loc, a.eh_locref2, a.eh_locref1) AS ref, a.eh_locref2, a.eh_title, a.eh_notes, a.eh_id, b.serialno, b.equip, b.modelno FROM equiphist a INNER JOIN equiplist b ON a.eh_id=b.recno WHERE (a.eh_loc1=:loc1 OR a.eh_loc2=:loc2) AND b.equip=:eq ORDER BY b.serialno, a.eh_date
| Date | Serial No. | Model | Action | Ref | Notes |
|---|---|---|---|---|---|
| Moisture Point | |||||
| 2001-11-10 | 000000402165 | PRB-K Type #8 | Installed | Installed near the understory tower by Dennis and Liukang | |
| 2001-11-10 | 000000402FF3 | PRB-K Type #8 | Installed | Installed near the water potential table and original sap flow measurements by Dennis and Liukang | |
| 2021-02-10 | 000000402FF3 | PRB-K Type #8 | Removed | Soil Moisture Probe F -0.50m | Removed from Tonzi floor due to fixed readings for a long while. This sensor was out of the ground at the edge of the trees near the path to the tower. It was buried vertically with the top of the sensor 31cm below the surface - the time were 44-50cm below the surface. |
| 2001-11-10 | 000000574632 | PRB-K Type #8 | Installed | Installed near the soil co2 measurements tower by Dennis and Liukang | |
| 2017-12-14 | 000000574632 | PRB-K Type #8 | Removed | Removed from the location inside the soil co2 profile fence. This probe has been giving bad readings for a while and its lowest pin is broken off. | |
| 2001-11-10 | 000000574B4B | PRB-K Type #8 | Installed | Installed near the Floor solar panels by Dennis and Liukang | |
| 2019-12-03 | 000000574B4B | PRB-K Type #8 | Removed | Removed from Tonzi near the Floor solar panels. This probe has three broken pins and has not been measured in a long time but this was the first time the soil was wet enough to remove it by hand. | |
| 2015-04-08 | 00000128B8072 | PRB-K Type #8 | Installed | Installed in a location near the main tower ground sensors to replace sn 000007931AFE that has a broken pin. | |
| 2016-11-17 | 00000128B8072 | PRB-K Type #8 | Removed | Removed from Tonzi near the main tower. This probe has two broken pins. | |
| 2015-04-08 | 000007931AFE | PRB-K Type #8 | Removed | Removed from a location near the main tower ground sensors due to a broken pin (2nd from bottom). Replaced by sn 00000128B8072 | |
| 2003-04-16 | 0000097A3B40 | PRB-K Type #8 | Installed | Installed at Tonzi second closest to big tree by Liukang | |
| 2003-04-16 | 0000097A3C6E | PRB-K Type #8 | Installed | Installed at Tonzi third closets to big tree by Liukang | |
| 2003-04-16 | 0000097A432E | PRB-K Type #8 | Installed | Installed at Tonzi furthest from big tree by Liukang | |
| 2003-04-16 | 0000097A4AAA | PRB-K Type #8 | Installed | Installed at Tonzi closest to big tree by Liukang | |
| 2005-01-27 | 00000A3D04E8 | PRB-K Type #8 | Installed | Installed at Tonzi by minirhizotron transect west of soil CO2 profiles | |
| 2024-01-02 | 00000A3D04E8 | PRB-K Type #8 | Removed | none | This probes has been broken for a long time - more than a year. Removed. It has a broken pin and the shaft is cracked. |
| 2005-01-27 | 00000A6D72F5 | PRB-K Type #8 | Installed | Installed at Tonzi by minirhizotron transect west of soil CO2 profiles | |
| 2005-01-27 | 00000A6D882B | PRB-K Type #8 | Installed | Installed at Tonzi by minirhizotron transect west of soil CO2 profiles | |
| 2016-11-17 | 00000FEDDAA1 | PRB-K Type #8 | Installed | Installed at Tonzi near the main tower to replace sn 00000128B8072 that has two broken pins | |