Equipment and Calibration
Equipment history at Tonzi| ALL | | Anemometer || Barometer || Battery Bank || Camera || CO2 Probe || Data Logger || Forced Diffusion || Gas Analyzer || Heat Flux Plate || Infrared Temperature || Interface || LED sensor || Moisture Point || Multiplexer || Narrow Band || Net Radiometer || PAR Sensor || Precipitation || Radio || RH & Temp || Soil Moisture Probe || Soil Water Potential || Solar Controller || Solar Panel || Water Level || Weather Station |
SELECT a.recno, a.eh_date, a.eh_loc1, a.eh_loc2, IF(a.eh_loc2=:loc, a.eh_locref2, a.eh_locref1) AS ref, a.eh_locref2, a.eh_title, a.eh_notes, a.eh_id, b.serialno, b.equip, b.modelno FROM equiphist a INNER JOIN equiplist b ON a.eh_id=b.recno WHERE (a.eh_loc1=:loc1 OR a.eh_loc2=:loc2) AND b.equip=:eq ORDER BY b.serialno, a.eh_date
| Date | Serial No. | Model | Action | Ref | Notes |
|---|---|---|---|---|---|
| Data Logger | |||||
| 2013-01-06 | 12213 | CR10X | Removed | Removed from the non-functional east sap flow station at Tonzi. | |
| 2024-10-29 | 13214 | CR10X | Installed | Data Logger StemFlux East | Installed east of the Floor tower to measure tree trunk temperatures for Kuno's stem flux experiment |
| 2016-07-07 | 19481 | CR10X | Removed | Removed from the Floor soil temperature, SHF, RH&T and Pres. These sensors have been moved to the CR23x collecting soil moisture. | |
| 2024-10-29 | 19481 | CR10X | Installed | Data Logger StemFlux North | Installed north of the Floor tower to measure tree trunk temperatures for Kuno's stem flux experiment |
| 2018-03-06 | 20138 | CR10X | Removed | Removed from Tonzi tower's old CO2 profile system b/c the profile system was not working. It was replaced by sn 47253. | |
| 2019-01-13 | 20138 | CR10X | Installed | Installed near the Floor solar panels to record temperatures from a concrete cal panel for the FLIR thermal camera. | |
| 2010-12-09 | 20139 | CR10X | Removed | This data logger was removed with the IRT sensors from Tonzi. | |
| 2010-03-19 | 20140 | CR10X | Installed | Given to Siyan to install in the supplemental solar radiation measurements near the tram and floor system. | |
| 2011-02-03 | 20140 | CR10X | Removed | Removed from Tonzi Floor. This data logger was recording up and down PAR, net and shf from the open space near the floor solar panels and net, RH and T and shf from under the trees. | |
| 2018-02-07 | 2113 | CR6 | Installed | Installed on Tonzi Tower for the Vaisala GMP CO2 profile. | |
| 2022-06-07 | 2143 | CR23X | Removed | none | Disconnected and packed up on 05/26 but brought back to the lab today - no longer needed |
| 2002-06-20 | 2301 | CR23X | Installed | Data Logger Soil CO2 | Installed with the initiation of soil CO2 gradient measurements |
| 2022-10-05 | 2301 | CR23X | Removed | Data Logger Soil CO2 | The soil co2 gradient system has not been in good condition for a long time. Finally getting around to removing the equipment from the field. |
| 2022-11-03 | 2301 | CR23X | Installed | none | Installed with the IRT sensor sn 7385 from the cal panel near the Floor solar panels for an IRT calibration for Robert's Oakley bike transect data this past summer |
| 2022-11-17 | 2301 | CR23X | Removed | none | Removed from Tonzi at the conclusion of the IRT calibration along with IRT sensor sn 7385 |
| 2010-03-16 | 25799 | CR10X | Installed | This data logger was installed with new supplemental radiation and air temperature sensor inside the floor cow fense. Problems getting final storage data dumped - will have it swapped out by next visitor. | |
| 2010-03-21 | 25799 | CR10X | Removed | This data logger was swapped out by Siyan from the floor supplemental radiation and temperature system. Final storage data is corrupt. | |
| 2013-10-18 | 31308 | CR10X | Removed | The tram derailed at the far end of the track not stopping and reversing direction. Initially it reset okay moving to park, but it did not run on the hour. The data was corrupt, but I was able to upload programs and a new OS in the field. It still would not run. I brought it in for fixing. | |
| 2024-10-29 | 3501 | CR10X | Installed | Data Logger StemFlux West | Installed west of the Floor tower to measure tree trunk temperatures for Kuno's stem flux experiment |
| 2010-02-10 | 38347 | CR10X | Removed | This data logger was removed from Tonzi. It was used for sap flow just west of the floor tower. AM416 sn 14049 was removed with it. Wiring panel is 28250. | |
| 2012-01-09 | 38970 | CR3000 | Installed | Installed in the Campbell Enclosure at SP1 inside the soil co2 fence. This is the initial setup of the site by Richard Cuenca and Yutaka Hagimoto of Oregon State Univ. | |
| 2023-06-16 | 4190 | CR1000 | Installed | none | Installed at the tower top as part of the Arduino RSB diffuse PAR prototype to compare with the BF5 |
| 2023-07-06 | 4190 | CR1000 | Removed | Removed from the Tower Top where it was part of the Arduino based RSB diffuse PAR prototype | |
| 2012-01-09 | 41907 | CR1000 | Installed | Installed in the Campbell Enclosure at SP3 southeast of the Tower. This is the initial setup of the site by Richard Cuenca and Yutaka Hagimoto of Oregon State Univ. | |
| 2012-01-09 | 41909 | CR1000 | Installed | Installed in the Campbell Enclosure at SP2 near the Tower. This is the initial setup of the site by Richard Cuenca and Yutaka Hagimoto of Oregon State Univ. | |
| 2018-03-06 | 47253 | CR10X | Installed | Installed at Tonzi to try to fix the CR10x running the tower's old CO2 profile system. It replaced sn 20138. | |
| 2018-05-23 | 47253 | CR10X | Removed | Removed from the Tonzi Tower with the old CO2 profile system. New Vaisala profile system is running | |
| 2016-10-13 | 47772 | CR10X | Removed | Removed from the non-functioning sap flow station north of the road | |
| 2019-04-16 | 47772 | CR10X | Removed | Removed with the wooden cal panel for the FLIR because cows chewed the TC wires and the new cal panel is better | |
| 2019-05-30 | 47772 | CR10X | Installed | Installed near an oak tree about 25m north of the Floor solar panels to support two IRTs | |
| 2022-06-07 | 47772 | CR10X | Removed | Disconnected and packed up on 05/26 but brought back to the lab today - no longer needed | |
| 2016-10-13 | 48042 | CR10X | Removed | Removed from the non-functioning sap flow station within the Tower cow fence | |
| 2015-05-06 | 66249 | CR1000 | Installed | Data Logger IRT | Installed at Tonzi to the east just north of the road. This data logger is collecting data from the two IRT sensors |
| 2020-03-02 | 66249 | CR1000 | Maintenance | Data Logger IRT | I changed this data logger Pakbus id from 1 to 49 - the last two digits of its serial number. |
| 2024-04-22 | 66249 | CR1000 | Removed | Data Logger IRT | Removed from the IRT tripod because cows had chewed the wires off. |
| 2024-06-04 | 66249 | CR1000 | Installed | Data Logger IRT | Reinstalled at the little tree northeast of the Tower at Tonzi after having been removed to repair massive cable damage from cows |
| 2015-04-08 | 66250 | CR1000 | Installed | Installed with the Handar wind profile near the Floor tower. | |
| 2015-12-23 | 66250 | CR1000 | Removed | Removed from the box for the wind profile near the Floor tower. | |