Equipment and Calibration History
View Equipment |
| Date: |
2020-02-25 |
| From: |
Lab - |
| To: |
Lab - |
| Title: |
Tested |
| Notes: |
I tested this sensor in the lab and could not get it to work. I used the current-to-voltage board provided with the sensor connected to a CR1000. I also connected a multimeter in place of the current-to-voltage board to measure the current. Both setups showed no response even when dunking the sensor in about 1.5m pipe filled with water. I recommend disposal. |
| Entered by: |
Joe Verfaillie |
|
|
