| Date: |
2017-01-06 |
| From: |
Lab - none |
| To: |
Lab - none |
| Title: |
Upgrade |
| Notes: |
Upgraded firmware to correct for W bug.
Old SN: Y124215
New SN: X124215
Upgrade file: Y074417-Y124215-m.gcu, Y012345-s.gcu, X120908 X124215-m.gcu
Old firmware: 2329-114
New firmware: 2329-116-01
All Checksum fields report PASS.
There are multiple upgrade .gcu files. During the initial upgrade using file "Y074417-Y124215-m.gcu," the sensor was set at 57,600 baud rate. This baud rate caused an error in the upgrade, so the SN reset to Y012345. Gill sent me the second upgrade file, "Y-12345-s.gcu," which reset the sensor to SN X124215. Finally, I used the third upgrade file, "X120908 X124215-m.gcu," to upgrade the firmware.
Log file: WMUpgradeLog_X124215_170106_123318.txt
Config file below. If there are two entries in a field, the first entry is the old setting and the second entry is the new setting.
-------
THE FOLLOWING FIELDS HAVE CHANGED
Baud Rate : 19200
Baud Rate : 57600
Output rate : P1 1 Hz
Output rate : P8 20 Hz
Output Channel 3 : W output (full range = 30m/s)
Output Channel 3 : W output (full range = 5m/s)
THE NEW CONFIGURATION IN FULL
==== DETAILS OF DETECTED ANEMOMETER========================
Serial Number : X124215
---- SW VERSION --------------------------------------------
Anemometer Firmware Version: 2329-116
---- HW DETAILS OF ANEMOMETER------------------------------
Detected Anemometer Class : WindMaster 20Mhz
Number of AXIS on this unit : 3
DAC resolution of attached unit : 14
Number of DAC channels : 4
Maximum sampling rate : (8) P8 20 Hz
---- USER CONFIGURATION OF ANEMOMETER----------------------
Baud Rate : 19200
Baud Rate : 57600
Output Message Format : M1 UV(W)
Output Message Velocity Units : m/s
Output Message Terminator :
Retries : ON
Instantaneous Sampling : OFF
Factory Calibration : ON
Physical Communications : Auto
Resolution settings : High resolution
Alignment settings : North to spar
Averaging settings : Averaging inactive
Output rate : P1 1 Hz
Output rate : P8 20 Hz
Polar angle minimum magnitude: 0.050 m/s
Power-On Message : Display Power On Message
ASCII Format : Comma Separated (CSV)
SOS and Sonic Temperature display : SOS
Analogue output mode : -5V to 5V
Unit Identifier : 'Q'
Output Channel 1 : U output (full range = 30m/s)
Output Channel 2 : V output (full range = 30m/s)
Output Channel 3 : W output (full range = 30m/s)
Output Channel 3 : W output (full range = 5m/s)
Output Channel 4 : Speed of Sound
|
| Entered by: |
Daphne Szutu |
|
|
