Equipment and Calibration
Equipment history at Bouldin Corn| ALL | | Air Quality Sensor || Anemometer || Barometer || Camera || Data Logger || Forced Diffusion || Gas Analyzer || Heat Flux Plate || Infrared Temperature || Interface || Multiplexer || Narrow Band || Net Radiometer || PAR Sensor || Precipitation || Range Finder || RH & Temp || Soil Moisture Probe || Solar Controller || Water Level || Weather Station |
SELECT a.recno, a.eh_date, a.eh_loc1, a.eh_loc2, IF(a.eh_loc2=:loc, a.eh_locref2, a.eh_locref1) AS ref, a.eh_locref2, a.eh_title, a.eh_notes, a.eh_id, b.serialno, b.equip, b.modelno FROM equiphist a INNER JOIN equiplist b ON a.eh_id=b.recno WHERE (a.eh_loc1=:loc1 OR a.eh_loc2=:loc2) AND b.equip=:eq ORDER BY b.serialno, a.eh_date
| Date | Serial No. | Model | Action | Ref | Notes |
|---|---|---|---|---|---|
| Interface | |||||
| 2017-04-26 | 13056 | NL115 | Installed | none | Installed at BC with initial set up of site |
| 2022-05-27 | 13056 | NL115 | Removed | Interface NL115 | I could not get this card reader to work with either of two CF cards. Removed for testing in the lab. |
| 2022-07-14 | 13056 | NL115 | Installed | Interface NL115 | Installed on the BC met CR1000 to replace sn 6761, which was brought back to the lab for testing. |
| 2022-06-09 | 6761 | NL115 | Installed | Interface NL115 | Installed on met CR1000 at BC and connected to Stardot phenocam |
| 2022-07-14 | 6761 | NL115 | Removed | Interface NL115 | Removed from BC and brought back to the lab for testing. The bottom 1/2-1/3 of phenocam photos is gray. Could be an interface or a card problem. It was replaced by sn 13056. |
| 2017-10-04 | AIU-0614 | LI-7550 | Installed | Interface LI-7550 | Installed on the Bouldin Corn tower to replace sn AIU-1570 for testing in the lab for bad headers and 7700 drop outs during wash cycle. |
| 2019-12-02 | AIU-0614 | LI-7550 | Removed | Interface LI-7550 | Removed from Bouldin Corn site and brought back to the lab after the tower fell down during a rain/wind storm on 2019-11-26. |
| 2019-12-13 | AIU-0614 | LI-7550 | Installed | Interface LI-7550 | Re-installed at Bouldin Corn after re-assembling tower. |
| 2021-01-29 | AIU-0614 | LI-7550 | Removed | Interface LI-7550 | Removed due to the tower falling over in the storm near midnight on 2021-01-26/27. |
| 2023-03-08 | AIU-0674 | LI-7550 | Installed | Interface LI-7550 | Installed at BC tower to replace sn AIU-1866 which was removed because of power problems |
| 2017-04-26 | AIU-1570 | LI-7550 | Installed | Interface LI-7550 | Installed at the Bouldin Corn site with the initial set up of the tower. |
| 2017-08-23 | AIU-1570 | LI-7550 | Upgrade | Interface LI-7550 | Upgraded the 7550 firmware from v8.0.0 to v8.7.5. I confirmed the 7550 time, time zone, sonic analog settings, and CO2 and CH4 logging config. |
| 2017-10-04 | AIU-1570 | LI-7550 | Removed | Interface LI-7550 | Removed from the Bouldin Corn tower for testing in the lab for bad headers and 7700 drop outs during wash cycle. Replaced by sn AIU-0614. |
| 2021-02-03 | AIU-1866 | LI-7550 | Installed | Interface LI-7550 | Installed on the BC tower to replace sensors damaged when the tower fell last week |
| 2021-04-15 | AIU-1866 | LI-7550 | Upgrade | Interface LI-7550 | Upgraded firmware from v8.5.0 to v8.8.32 |
| 2023-03-02 | AIU-1866 | LI-7550 | Removed | Interface LI-7550 | Unit is receiving 24V but no LED lights and couldn't connect. Removed from BC tower and brought back to the lab for testing. |